Marko Makaj
patreon
No man can kill me ... part 3 :D
🕑 Added 2024-02-05 20:08:40 +0000 UTCThe iconic movie prop part of the month came early :D
And after the 2 weapons, it was pretty clear this one had to be made :D
Before I continue - the February folder has been sent, you will find that model in there ( we are makers tier member) , and everything else i release this month :)
Ok back to the Witch king's crown :)
I did quite some effort to make the shape and proportions as close as possible to the real deal. I've seen quite a few models, but the eyes, forehead, cheeks, all of these felt very off, so I hope you will find my version to your liking :) I also did my best to create a printable textured version, to make it even closer to the real deal, and this one is printing right now, and i have to say, it's quite badass :D
The entire thing is 3 mm thick, so it's not too heavy. and the spikes can be printed without support, just make sure to rotate the parts where there could be overhangs to your cooling vent.
Included are:
- Fully combined option - clean and textured versions
- split into parts option - clean and textured versions
- split into parts presliced for small printers option - clean and textured versions
- crown spikes split version for supportless printing
the Crown spikes are all a tiny bit different so make sure to put the right one into the right slot (#1 starting at right eye, all the way around)
Happy printing :)
Comments
Marko Makaj
If you are at the "we are makers" tier, the folder is in your inbox :) FEBRUARY 2024 folder. If you still csnt find it, please drop me a message i will resend it :)
Tufenuf
How do you gain access to the file?
Marko Makaj
And those are the parts i have trouble finding good references :/ he's always covered up , and the "official" statues are each diferent so not sure what to think of that :D
Anthony
All that's missing are the shoulders, gauntlets and boots. :)
