customminiaturemaker
patreon
Rocky Plateaus
🕑 Added 2024-08-21 19:25:27 +0000 UTCHey Miniature Makers!
This week our latest creation is this 4-pack of Rocky Terrain. A great solution for many different fantasy or wargaming settings!
Paint them up with some sandy tones for a Desert Rock appearance, or with some undertones of purple, green, and blue for an alien planet. These could even find their way onto a frost-covered mountain with some greys, blue, and whites!
Plenty of options to customize these for your specific setup, and room to add things like rocks, gravel, shrubs, and trees.
They range in size from 2.5 to 4.5 inches wide and about 1.2 to 2.2 inches tall, giving you some nice variation for a more natural-looking arrangement.
We hope you enjoy them!
INCLUDES:
Rocky Plateaus (4 sizes)
They come laid flat for FDM and Fully Pre-supported for Resin printing.
How to Download
Now added to your MMF library for August
Keep on Rollin' Simon & Justin
Comments
DrVesuvius
Normally I'd be tempted to agree with you, but it all comes down to what resources you have available and how best to use them. I don't have any suitable foam at the moment, and more significantly kittke energy or free time. However I do have two FDM printers sitting idle and a stockpile of PLA. I can set these printing one a day, and wind up with minimal effort and no additional expense (sure, the PLA will have cost, but I already have it, whereas I'd have to order some 50mm XPS, which would be extra expense.)
Ryan Snyder
I'll probably print 4-6 of them. Quick scatter for my D&D group. If I was doing anything larger I would definitely use foam because even a full sheet is cheaper than printing them.
Belinda
Useful. But I'm curious how many will print these? Not a criticism, but certainly cheaper to carve in foam.
JEG301
I am pleased!
