1usmus
patreon
HYDRA CORE CURVE CONTROL - HOW TO USE
🕑 Added 2023-08-01 14:41:57 +0000 UTCQ: - How to change the offset value for all points at the same time?
A: - For simultaneous offset increase or offset decrease the user has access to 2 keys, the icons on which indicate in which direction the offset will be changed. The step is 10MHz. Very useful function if you have detected instability after diagnostics. Try 1 or 2 steps down.
Q: - I want to set a voltage limit (or undervolting) for the curve, how do I do this quickly?
A: - You will only need 2 clicks. First click - select the value on the table that should be the limit, in my case it is 850mV. The second click on the button with the scissors icon - it will automatically "cut off" the part of the curve that the video card will not use. This key is your friend also if you need undervolting.
Q: - I want to set the offset for all points of the curve at the same time, but I don't want to use the step up or step down tool (down and up arrow icon buttons), how do I do it?
A: - You will need 2 actions. The first is to enter the desired value in any cell of the table and select it. Second - click on the synchronization button (pictogram with two arrows pointing at each other).
Q: - I want to "reset" all offsets, i.e. return the curve to the factory state, how to do it?
A: - Just click on the button with the eraser icon.
Q: - Is it possible to combine the offset synchronization function (sync button) and then use the curve trimming function (cut button)?
A: - Yes, you are completely free to experiment.
______________________________________________________________________________________________________
NOTE 1. If you are satisfied with the changes, click on the button with a tick icon, if you do not want to apply the changes - click on the button with a cross icon.
NOTE 2. In order for the adapter(s) settings to be applied, make sure the "profile-switching" feature is active and highlighted (on/off icon). If it is not active, click this button.
If there are settings in the system that differ from the settings saved in the file, you will see an highlighted button with a floppy disk icon. To change the button-status it is enough to click on it.
To the right of the button to enable "profile-switching", there will be information about which profile is currently active.
