toms3dp
patreon
Hangout time? Everyone's invited!
🕑 Added 2019-06-08 09:24:21 +0000 UTCUsually these Hangouts are reserved for Patrons in the "Inquisitor" tier, but every now and then I think it's fun to invite all of you on a Q&A and hangout - so leave your questions in the comments below or ask live in chat during the stream!
You can find the exact time for you on the YouTube page. See you then!
Comments
Thomas Sanladerer
Simply throw it in the oven - PLA at 40-ish °C for an hour or more, PETG at 60-ish for two or three hours. Food dehydrators have also been reported to work well if you're not comfortable with heating your filament in the same oven you prepare food in ;-)
Thomas Herrmann
Missed it :(
Phil Kelly
Just missed the livestream :-(. What is your recommended filament drying solution?
Pinkmouse
So have you come across the Bigtreetech SKR V1.3 32-bit boards yet? Just bought one on impulse to try out, and it seems pretty well made. Is this the board to finally bring 32 bit to the masses?
Pinkmouse
Hi Tom
