Nate Miller
patreon
Slime Blower Pack for Vintage Kenner Figures
🕑 Added 2021-09-20 00:52:44 +0000 UTCThese are likely my favorite custom "Kenner" accessory that I've designed so far. When GB2 was out in theaters in '89, I always wanted a slime blower pack for my Ghostbusters toys. I made these 3D printable packs to plug into the vintage figures just like the original Kenner packs.
A few notes:
- I printed mine using .12 mm layer height and about 20% infill
- I used a silver silk metallic PLA filament by CC3D
- The blower and pack are connected using a 22 awg wire
- I recommend printing the pack in the 'vertical' orientation
I made some modifcations to the file since I printed mine - namely I added in the "headlight" shapes on top of the side tanks and I added some side clips so you can mount the blower weapon.
I am making this material and content for the 3D Printed parts available under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. License text is included in the attachment!
Comments
Nate Miller
I can do that!
Ian Raulston
Any interest in making these compatible with the 5” Afterlife figure pegs?
Mike Lorusso
Amazing as always!
