marcoreps
patreon
Difficult is good, but ...
🕑 Added 2018-02-07 11:43:59 +0000 UTC ... getting into DIY quadcopters is just overwhelming. I got this Beebee 66 micro racing quadcopter and there is absolutely no info available anywhere. They just assume that everyone knows about transmitters and receivers, iBus and PPM, betaflight and angle mode, accelerometer calibration, arming, ........I am thinking about bypassing all that (artifically ?) complicated stuff and just controlling the brushless motor drivers with a microcontroller directly. But then again it might be complicated for a reason?
Either way there will be a LoRa controlled long-range quadcopter at some point.
I even got that extra strong braided fishing line, that someone suggested for the antenna mast.
Comments
Dermot Conner
What Volodymyr said. Fun to watch you try, but that way lies madness.
Fred Fernandez
This should do the trick. :) <a href="https://www.youtube.com/watch?v=iURdanOCFIA" rel="nofollow noopener" target="_blank">https://www.youtube.com/watch?v=iURdanOCFIA</a>
yeah if you get 70Kilo braid - that will be a tough job to snap in a gale! it'll cut through the mast anchorages first I reckon - Watch your fingers!!!!! I have fetched 40Kg Ling up 250m from the bottom of lochs effortlessly (except the mad thrashing around) with that stuff and I could feel every little movement all the way to the bottom - absolutely no stretching. I don't fish with anything else now.
Volodymyr Babchuk
"I am thinking about bypassing all that (artifically ?) complicated stuff and just controlling the brushless motor drivers with a microcontroller directly. " Heh... When youll finish your firmware, you'll got second betaflight :)
Marco Reps
I may be pampered a bit by my 3DR Solo experiences, but there wasn't even something like a connection diagram for the Beebee 66 telling me what to solder where. Neither is there any info about the flight controller because it's their own miniaturized clone of a copy of a branch of something else. Ah well I think I got it now more or less :)
ulf karlsson
For help with the quad check out Joshua bardwell or Bruce Simpson. They have beginner tutorials for RC stuff. It's really not that complicated.
